Roll core made of heart-shaped jewelry box

Paper core making heart-shaped jewelry box craft materials: paper core, cardboard, non-woven fabric, ribbons, beads, adhesive tape, scissors, needle


1. The roll core is cut halfway from the middle.
2, then longitudinally split into two halves from the middle. (After the points are good, put them together is not symmetrical)
3. Tape the two semi-curved sides together.
4, according to the width of the half arc, cut a piece of cardboard, the length of the cardboard determines the shape of the heart shape, short, the shape is flat, so the length is determined according to individual requirements.


5. Fold the cut cardboard into a "V" shape and fix it with tape and two semi-arcs.
6. Draw two heart shapes on the other piece of cardboard (using a slightly thicker cardboard, such as corrugated cardboard ), one of which is slightly smaller.
7. Cut the non-woven fabric into the corresponding shape as shown in the figure: 2 strips in length and 4 pieces in heart shape.
8, with two long strips, inside the periphery. (Sew one side first, put it on the paper box and sew the other side)


9. The upper and lower pieces of the heart shape wrap the cardboard and are stitched around. Use a smaller heart shape as the bottom and connect to the side of the box. The larger heart-shaped cover is attached to the side of the box only at the top of the two curved shapes.
10. Make 3 small roses with pink ribbons.
11. Use a green ribbon to tie the bow , put a rose on it, and fix it on the lid with hot melt adhesive.
12. Sew a circle made of a glittering band on the inside of the sharp corner of the lid. A box of beads is placed next to the box. This way the lid can be buckled.