[Office Partner Information Center] How to clean the touch inquiry machine? Spray on a towel with a glass cleaner or alcohol and wipe the glass surface with a towel. In general, the dust on the glass surface can be wiped off directly with a dry towel. If it is a touch display, it can be easily wiped off by the business card or hard paper through the gap between the front cover of the display and the touch screen. Does dust have an effect on usage? Dust in the viewable area of ​​the display does not have any effect on the touch inquiry machine, but if the reflective stripes around the touch screen cover too much dust, the touch screen will gradually lose the touch function. At this time, cleaning the dust around the touch screen will return to normal. You can use a business card or bank card to cover the gap between the cabinet frame and the touch screen with a thin cloth strip to remove dust. What is the status of the touch control box indicator under normal circumstances? During normal operation, after two seconds of power on, it will turn off after three seconds, and it will be on when there is a touch, and it will be off when there is no touch. If it is in other states, please check the hardware connection. Why do you sometimes find that the mouse is always at a certain point on the four sides of the monitor? This is mostly because the touch area is pressed too tightly by the display case or cabinet housing, which is equivalent to a point being touched. If the cabinet case is pressed against the touch area, you can slightly increase the distance between the cabinet and the monitor screen; if the display case is pressed against the touch area, you can also try to loosen the screws on the display case. Why do the touch points sometimes deviate from the mouse arrow? This phenomenon is what we often call mouse drift. Generally, the surface acoustic wave screen has such a phenomenon, because a large amount of dust or scale accumulates on the sound wave reflection fringes on the four periphery, which affects the transmission of the sound wave signal. Please use the above method to wipe the surrounding area clean. When cleaning, be careful to disconnect the power of the touch screen control card. Why does the touch inquiry machine sometimes have a long response time? It is possible that the touch-checking machine has a moving water droplet stuck on it, and the water droplets affect the operation of the touch-one machine. Please wipe it with a soft dry cloth. Why does the mouse touch or move in a small area? This is usually the case with the first drive. Please run the touch screen calibration program. You must also run the touch screen calibration program after changing the display resolution. After the external power is turned on, the display is on. Why can't the host start after pressing the power reset switch after the cabinet? Please check whether the power cord plug on the power socket in the cabinet is plugged in; the same reason, the host can start normally, but the monitor does not display. Check the plug on the socket. Electric Mill Grinder,Electric Mill Grinder Grinder High-Speed,Electric Salt Mill,Automatic Pepper Grinder Yongkang Lianyang Industry & Trade Co., Ltd , https://www.yklianyang.com
Touch screen integrated machine some common small problem handling methods