The toilet is a sanitary ware that we have in every family. A good toilet can not only make our health life more convenient, but also improve our bathroom taste. There are many styles of toilets on the market today, but the structure of the toilet is very similar. Today we will explain the structure of the toilet! Toilet bowl structure diagram: The working principle of the toilet: The water enters the water tank through the pipe installed with the angle valve. As the water level increases, the floating ball will rise together. When the float reaches a certain height, it will seal the inlet pipe line (mainly through the figure The waterstop rubber seal is shown closed. The water tank is no longer filled with water. When the flush button is pressed, the water stop rubber ring in the lower part of the tank is pressed and opened so that the water will flush into the toilet seat. The specific pumping principle is as follows: The “pumping†of the toilet refers to the S-curve under the toilet. When the sewage in the toilet exceeds the high point of the S-bend during the drainage, the siphoning phenomenon is formed and the water and dirt of the toilet can be taken. Take it away. Until only a small amount of water remains, the siphon is destroyed, leaving behind a small amount of water, forming a water seal. Inlet valve: The float valve, through the rise of the water level, to enhance the closure of water. If the toilet tank is filled with water, it may be caused by the fact that it cannot be closed. Here, you can use the remaining adjustment to control the level of the tank water level. This eliminates the need to put a bottle of water in the tank to save water, like some old people. Drain valve: It is normal that we press the button to flush the interior of the toilet water. The two size buttons correspond to the black and white buttons above. Overflow pipe: If the front inlet valve cannot be closed, or the adjustment is too high, it is higher than the overflow pipe, then the excess water will flow from this pipe into the toilet, so that the water tank will not enter the water all the time and the toilet will be submerged, causing unnecessary loss. If it is found that the toilet is always running out, you can check if it is left from here. If it is, adjust the front inlet valve. There will be a button on the front of the toilet with a flat-blade screwdriver. It will open and move up and down. The proper position is buckled and the position cannot be higher than the overflow pipe. Drain valve: He is the most vulnerable place in the toilet. We can turn it counterclockwise to check it off. There is a plastic piece on the top of the plug that regulates the amount of water. We can adjust it up and down. Control the size of the flush volume. There are two small buttons on the toilet tank, as shown: One big and one small, is the control button of large amount of water and small amount of water, there are two pillars on the button, those two pillars are against the drain valve, open the drain valve by pressing, realize flushing. If there is a constant flow of water from the lid on the lid of the toilet seat, then the pillar below the button is too long. It can be adjusted to a suitable position by the knob, and it will not flow. <\p><\div>
dishwasher safe, lightweight, top rack, easy to clean
we are the manufactuer that speically produce melamine and plastic products
the factory has Walmart, BSCI and Tchibo audit
our proudcts can pass EU NEW STANDARDS, LFGB AND FDA
we have our own lab
will do the test for each shipment to make sure all the goods are safety.
Melamine Dinnerware Set,Melamine Plates,Melamine Dinner Set,Melamine Dinnerware TAIZHOU SHALL HOUSEWARE MANUFACTURING INC. , https://www.shall-melamine.com
chip resistant, for all serving usage of indoor and outdoor
durable , BPA free
vintage
The structure of the toilet solution!